1996 Ford Aerostar/Ranger/Explorer Camshaft Position (CMP) Sensor REMOVAL AND...
download CAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) or T96T-12200-A (5.0L) must be obtained prior to installation of the replacement synchronizer assembly. Failure to follow this...
View Article2006 Ford Explorer 6R60 Transmission Selector Lever Cable REMOVAL AND...
download Selector Lever Cable Vehicles Equipped with a 6R60 Transmission Removal All vehicles 1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section...
View Article1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation
download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to...
View Article2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View Article2002 Chrysler 300M Special GEAR SHIFT CABLE – FLOOR / REMOVAL 42LE –...
download 1. Using suitable size allen wrench, remove the shift handle retaining screw (Fig. 251). 2. Remove shift handle from shifter assy. 3. Remove console bezel from vehicle. 5. Remove retaining...
View Article1997 Ford Explorer Cable and Conduit Parking Brake Rear Removal
download 1. NOTE: Make sure the parking brake control is fully released. Relieve the tension on the parking brake system. 1. Pull the front parking brake cable and conduit. 2. Insert a suitable...
View Article2003-2006 Chevrolet Express Antilock Brake (ABS) Activation At Low Speeds...
download Condition Some customers may comment on ABS activation at low speeds, usually below 8 km/h (5 mph). Upon investigation, the technician will find no DTCs set. Cause The cause of this condition...
View Article1999 Ford F-Super Duty 250-550 Automatic Transaxle/ Transmission Cable and...
download 1. NOTE: To prevent cable damage, do not apply force to the transmission shift cable assembly between the steering column shift tube bracket and the steering column bracket. Disconnect the...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article
More Pages to Explore .....